Tools; Dimensions and design
Ccontents:
Introduction
..................................................................................................................3
1
Scope of application
..................................................................................................4
2
References
.................................................................................................................4
3 Dimensions
.................................................................................................................4
3.1 General Comments
..................................................................................................4
3.2
Hollow taper shank
T
...............................................................................................5
4 Design
.........................................................................................................................8
4.1
Cavity for installation
Data Chip according to DIN 69873
..........................................8
4.2 Oorientation
notch
....................................................................................................8
4.3
clamping forces .........................................................................................................8
4.4 Access
hole on the taper
for the manual actuation
of the clamping systems ............9
4.5
Coolant supply ..........................................................................................................9
5 Ddesignation
.................................................................................................................9
Appendix
A (informative)
Recommendations for the use and application.....................10
A.1
clamping forces........................................................................................................10
A.2
Information about RPM,
torque, bending stress and
stiffness....................................10
A.3
Information on material and heat
treatment
.............................................................10
Rreferences
.....................................................................................................................11
Back